Fabric weight and width: compare GSM, linear metres and usable cutting width
Two fabric quotations can look comparable while describing different quantities. Before choosing wool or blended coat fabric, put weight units, finished width and usable cutting width on the same basis. This makes it easier to distinguish a genuinely different specification from a unit conversion, and to understand why the lowest price per metre may not produce the lowest fabric cost per garment.
Are you comparing area weight or linear weight?
GSM means grams per square metre (g/m²); grams per linear metre (g/m) describe one metre along a fabric roll at its stated width. For a uniform fabric measured on the same width basis, g/m = g/m² × width in metres. A hypothetical 400 g/m² fabric at 1.50 m therefore weighs about 600 g/m, not 400 g/m. These are illustration values, not a Fred Textile product specification. If selvedges differ from the fabric body, or the two measurements use different width boundaries, ask for the appropriate measured result rather than treating the conversion as exact.
Which width can the cutting room actually use?
- Separate nominal or full width from usable cutting width, and state whether selvedges are included in the measurement.
- Ask for the agreed measurement method, conditioning, width tolerance and the identified finished sample or production lot.
- Confirm whether recurring edge defects, finishing variation or the intended garment layout reduce the usable width further.
- Give the garment maker the agreed usable width before marker planning; a nominal 150 cm does not automatically mean 150 cm can be cut.
Put quotations on a common basis before comparing price
For a per-kilogram quotation, convert using the agreed finished mass per linear metre: kilograms per metre = grams per metre ÷ 1000. Multiply the price per kilogram by kilograms per metre to obtain a comparable price per linear metre. Check whether finishing, packing, delivery basis and testing are included before judging the difference. A wider fabric may offer more usable area per metre, but a price per square metre still cannot predict garment yield on its own. Pattern dimensions, size mix, checks and nap direction determine how the pieces fit within that area.
Confirm consumption with a trial marker, not a universal allowance
Request a marker or trial cutting plan from the garment maker using the correct size ratio, usable width, pattern repeat and direction requirements. Keep shrinkage or preparation allowances separate from pattern-matching waste and defects so the same allowance is not added twice. Record which fabric condition the width and weight refer to, and recheck the plan if the finish or width changes. ISO 3801 covers measurement of woven-fabric mass per unit length and area; it does not supply a universal purchasing tolerance or coat consumption figure. Confirm the selected style's specification and order conditions with Fred Textile before committing the bulk quantity.
Worked comparison: equal metre weight, different area weight
Consider two uniform fabrics both stated as 400g/m: at widths of 1.50m and 1.40m, their calculated area weights are approximately 267g/m² and 286g/m² respectively. Equal linear weights do not mean equal GSM. This example assumes matching measurement boundaries and condition; the rounded values are not acceptance tolerances. Convert centimetres to metres before using the equation and retain the original units in your comparison sheet.
Use a confirmation table with columns for weight unit, full or usable width, final finish, nominal versus measured value, tolerance and approval reference. Check whether a quoted or shipping weight is net fabric weight or gross weight including the tube and packaging; gross shipment weight cannot simply replace the net material weight in a price conversion. Record who confirmed the data and which sample or lot it describes. When values disagree, resolve the measurement basis before changing the order quantity. A calculation can reveal an inconsistency, but it cannot determine the supplier's accepted specification without confirmation.
Send the fabric reference and your garment maker's usable-width requirement through the contact page. Weight, tolerance, price basis and availability must be confirmed for the selected order.
Discuss your fabric specification