Back to Operation

Fabric inspection before cutting: turn a roll report into a clear acceptance decision

A statement that fabric was “inspected” does not explain what was checked or whether the roll is suitable for your garment order. Agree the inspection scope and acceptance rules before shipment, then connect the report to identifiable rolls when goods arrive. Visual inspection, laboratory performance testing and a garment trial answer different questions; none should silently stand in for the others.

Agree the inspection method before comparing scores

ASTM D5430 describes visual examination and grading of fabrics and contains different point-assignment options. Agree the method, edition, grading option, inspection extent and acceptance basis rather than assuming every “four-point” report is comparable. A threshold must be agreed for the order; it is not a universal Fred Textile guarantee. Also state how full-width faults, repeated defects and unusable lengths are recorded. A roll with a low overall score may still contain a fault in exactly the place required for a large garment panel, so the cutting decision needs the defect locations as well as the total.

Match each report to the rolls you received

  • Check style, colour, finish, dye-lot and roll identifiers against the packing list and the retained approval reference.
  • Record measured length and usable width using the agreed procedure; distinguish full width from cuttable width.
  • Locate defects by distance along the roll and, where relevant, across its width; identify repeated or continuous faults.
  • Keep photographs with a scale and roll reference, the inspection date, viewing conditions and any agreed reinspection result.

Do not use a defect score to approve shade or performance

Review within-roll and between-roll shade variation against the agreed colour standard and lighting. For textured or directional wool fabrics, check the fabric face and orientation before deciding that an apparent difference is a dyeing fault. Check weight, width and any separately specified dimensional stability, pilling or colourfastness reports on their own agreed basis. A visual grading total does not certify these properties. Ask whether the test specimen represents the final finish and the relevant lot; an unrelated development-sample report is not automatic evidence for every delivered roll.

Hold disputed material before it becomes cut garment pieces

Separate affected rolls, retain labels and approval samples, and send the report, defect map, photographs and quantity affected to the supplier. Discuss whether reinspection, agreed local exclusion, an alternative roll or another written resolution is appropriate before using the material. Do not assume a refund, replacement or cutting allowance has been approved merely because an issue was reported. Keep accepted and held material distinguishable in the cutting room and record any authorised use. Fred Textile's brochure describes final inspection; the actual inspection scope, acceptance limits and handling of a disputed lot must be confirmed in the order agreement.

Use the contact page to send a clear roll-level question with its reference and evidence. Agree the review and acceptance procedure before cutting; this guide does not establish automatic compensation terms.

Discuss your fabric specification