Back to Collections

What does “20,000 rubs” actually tell you about a wool coat fabric?

Imagine two swatches with the same number on their cards. For A, the laboratory stopped at 20,000 rubs with no breakdown. For B, it first observed breakdown at the 20,000-rub inspection. A has a recorded lower bound, not a measured failure point. Neither number tells you how many seasons a coat will last. This example is not a Fred Textile test result.

Read the sentence beside the number

Ask for the article, lot, final finish, face tested, method and edition, abrasive, pressure, inspection intervals and reason for stopping. ISO 12947-2 concerns specimen breakdown; ISO 12947-4 assesses change in appearance. Do not rank suppliers on counts from different procedures. For a coated or laminated construction, ask the laboratory for an applicable method rather than specifying Part 2 by default.

Decide what would make a cuff unacceptable

A brushed cuff can develop a shiny patch or lose its nap before the fabric breaks down. If that is the buyer’s concern, specify how the appearance will be compared with the retained original at an agreed interval. Ask for the specimens or comparable photographs. If little fibre balls are the concern, request a separate pilling assessment; a rub count is not a pilling grade.

Put the acceptance decision in the order

Write down the garment area, identified sample and lot, agreed test conditions, endpoint and acceptance rule. For example: “Assess breakdown and cuff-face appearance separately; if either result is missing, hold approval.” Agree the target with the buyer and laboratory before testing. A new finish or a report from another lot calls for a review, not automatic release.

Technical references

ISO 12947-2 · ISO 12947-4